NETGEAR Network Card MA111 v2 User Manual

Next, Install the MA111 Wireless USB Adapter  
Note: You should have a USB port on your computer. Newer USB 2.0 ports will  
2
Installation Guide  
also work.  
Wireless USB Adapter MA111 v2  
a. Insert the MA111 into a USB slot. After a short delay, the Found New  
Hardware Wizard displays. Click Next to proceed.  
Start Here  
Note: If a Windows XP logo testing  
warning appears, click Continue  
Anyway to proceed.  
Follow these instructions to set up your wireless adapter.  
These basic setup instructions assume that you will connect to an access point, and you are  
not using WEP security. Please refer to the online help and the Reference Manual on the  
Resource CD for instructions on configuring WEP, Ad-Hoc mode, or advanced options.  
b. The utility opens to the Status tab page.  
c. Click the Configuration tab page to change the wireless settings. Change the  
Network Name SSID to match your network.  
Estimated Completion Time: 5-15 minutes.  
Tip: To view the available wireless networks, use the drop-down list or the Site  
Survey tab and choose the one you want.  
b. Next, you will also be prompted to choose the country where you are located.  
For Windows XP computers  
d. Click Apply to activate the connection.  
First, Install the MA111 Software  
a. Power on your PC, let the operating system boot up completely, and log in  
as needed.  
1
Tip: Click the Profile tab page for profile creation. Create work and home  
profiles. Then, activate whichever one you need for your current location.  
Note: The Signal Strength and Link Quality indicators on the Status tab page report  
the status of your wireless connection.  
Click Yes to accept this option.  
b. Insert the Resource CD into your CD-ROM drive. The CD main page shown  
below will load.  
If you choose No, you must read the Windows XP documentation for an  
explanation of how to use the Windows XP wireless configuration utility.  
You will also be prompted to choose the country you are located in. Select your  
location from the list.  
Finally, Verify Wireless Network Connectivity  
a. Verify that the status monitor information at the bottom of the utility matches  
your wireless network.  
4
c. Click Finish to complete the installation. You will see the MA111 system tray  
icon  
on the lower right portion of the Windows task bar.  
b. Check the color of the MA111  
icon in the Windows system tray: green or  
red indicates no connection.  
yellow indicates a working connection;  
Now, Configure Your MA111 and Save the Profile  
3
c. Check the MA111 LED: blinking means attempting to connect; solid indicates  
a good connection; off means the MA111 is not plugged in.  
a. Click the  
icon in the Windows system tray to open the MA111 Smart  
c. Click the Install Driver & Utility link.  
Wireless Settings Utility.  
d. Follow the InstallShield Wizard steps. Click Finish when done, and if prompted  
d. Verify connectivity to the Internet or network resources.  
restart your computer.  
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation  
section of the Reference Manual on the Resource CD.  
 

Milwaukee Power Hammer 1854 1 User Manual
NAD Stereo Amplifier PP 2 User Manual
Nady Systems Microphone SCM 960 User Manual
NEC Personal Computer PA322UHD User Manual
Nesco Oven 18 Qt ROASTER OVEN User Manual
Nikon Camera Accessories G02 User Manual
Omnimount TV Mount NC200 F User Manual
Onkyo Stereo Receiver AV 3600 User Manual
Onkyo Stereo Receiver HT R538 User Manual
Panasonic Printer KX RC105 User Manual